SUREFIRE SUPP ALIGNMENT ROD 7.62MM

Description

A baffle strike on a suppressor is an expensive and potentially dangerous mistake, and it most commonly happens when the suppressor’s bore isn’t properly centered over the muzzle. The SureFire Bore Alignment Rod for 7.62mm gives you a definitive check before the first round goes downrange. SureFire recommends running this verification on any new suppressor setup or any previously unshot configuration, and this rod is how they intend that check to be performed.

The rod is precision-machined from heat-treated stainless steel to closely represent the actual bullet flight path through the suppressor. With the suppressor mounted on an unloaded weapon, you insert the rod through the bore and observe the gap between the rod and the suppressor’s interior. Equal spacing all the way around confirms that the barrel, adapter, and suppressor are properly concentric. If the rod makes contact with the suppressor, that misalignment needs to be resolved before shooting — not after.

Heat-treated stainless steel gives the rod the rigidity and dimensional stability needed for a reliable measurement — a softer material would risk flex that could mask a real alignment problem or create a false one. SureFire offers caliber-specific rods so the diameter genuinely reflects what the bullet will do, rather than using an undersized rod that leaves too much margin to catch a subtle but consequential offset. This is a purpose-built tool from the same manufacturer that makes the suppressors it’s designed to protect. Made in the U.S.A.