C&H PLT CZ P10 TO HOLO 407K

Description

The C&H Precision adapter plate for the CZ P-10 Optic Ready series bridges the gap between your factory slide cut and the Holosun 407K or 507K footprint. Without a plate like this, an optic-ready CZ P-10 running a 407K or 507K sits in a cut sized for a different footprint entirely, leaving the optic insecure and the mounting screws without meaningful engagement. This plate solves that by giving the optic a precision-machined surface to bear against and, critically, a set of stainless steel T-nuts that provide substantially more thread engagement than a standard tapped aluminum hole would allow. More thread engagement means the mounting hardware is less likely to work loose under sustained recoil, and it also means a stripped screw costs you a T-nut replacement rather than the entire plate.

The plate itself is machined from 6061 aluminum and finished in MIL-SPEC Type III hard anodizing, which puts a harder surface layer on the aluminum than standard anodizing and improves its resistance to wear at the optic interface. All mounting hardware is stainless steel. Compatibility covers the CZ P-10 C, P-10 F, P-10 S, and P-10 V4 MIL/LEO variants in their optic-ready configurations. Included hardware covers both the plate-to-slide screws and the optic-to-plate screws, so no additional hardware is needed for a basic installation. C&H recommends dry-fitting all components before final assembly, since tolerances can stack across the plate, optic, and slide in ways that are easier to address before thread locker is applied.