YANKEE HILL MACHINE COMPANY VICTRA-12 THREAD PROTECTOR

Description

When you remove the VICTRA-12 suppressor from its mounting device, the exposed threads need protection from debris, handling wear, and the kind of incidental contact that degrades a precision thread over time. This thread protector is the straightforward solution YHM designed specifically for that purpose — it seats on the VICTRA-12 mounting interface and keeps the threads in serviceable condition between uses.

YHM machines it from 6061-T6 aluminum, which keeps weight negligible while offering enough structural integrity to guard against anything the threads are likely to encounter in storage or during transport. The hard coat anodized finish adds a layer of abrasion resistance that bare aluminum would not provide on its own, so the protector itself holds up through repeated installation and removal without introducing galling or corrosion into the equation.

At 0.530 inches long and 1.2 inches in diameter, it sits flush enough to avoid snagging on cases or slings, and the dimensions are matched to the VICTRA-12 system rather than adapted from a generic profile. If you run a VICTRA-12 suppressor and take it on and off with any regularity, this is the kind of small accessory that prevents a much larger problem — a damaged mount thread is an expensive fix, and a few dollars of protection installed every time the can comes off is the more practical approach. Made in the USA by Yankee Hill Machine.

Shipping and availability: This item must ship to a licensed FFL dealer for transfer.